Rubber Process Analyzer manufacturer takes you to understand what needs to be calibrated
The Rubber Process Analyzer manufacturer tells you that the accuracy of the data displayed by any test equipment depends to a large extent on its calibration method. Only after the test equipment is calibrated according to recognized standards can basic information such as this be obtained.
However, in complex machines, the specific aspects that need to be calibrated or the degree of operating accuracy required are not clearly defined. The Rubber Process Analyzer manufacturer tells you that these include equipment used for footwear testing. For these special cases, it is necessary to define the characteristics that need to be calibrated.
Usually, this depends on the test method used to design a particular device. The Rubber Process Analyzer manufacturer tells you at the beginning that these assessments may be very simple. For example, checking gauge readings is important to the accuracy of material thickness. However, some potential factors may also need to be checked, which may change the measured thickness. For example, the parallelism between the anvil and the presser foot and the pressure applied to the material under test affect the results.
The necessary parameters for calibrating the machine should be clearly stated in the test method used. The Rubber Process Analyzer manufacturer tells you that any slight difference between the machines used in different laboratories may cause significant differences in test results. These methods should also state acceptable tolerances, although some methods may only specify a certain value for a particular parameter without specifying any tolerances.
The latter caused many problems. The Rubber Process Analyzer manufacturer tells you that the measured value should be exactly equal to the nominal value, or is the close result satisfactory? Also, how to define "closed" in this case? This means that the nominal values specified in the test parameters are useless when determining the suitability of the machine.
The Rubber Process Analyzer manufacturer tells you that if the tolerance is not specified, it is the user's responsibility to determine the suitability of the test machine.